Fence construction · Own production
Fence post brackets and fittings
Brackets, clamps and connectors for welded wire mesh panels and posts — dimensionally matched to each other, corrosion protected and ex stock Germany. Fence fixings are one of our core products and come from our own production and our own tool shop.
System
A bracket for every fence element
Join panel and post, or panel and panel, quickly and securely — sized for the common post dimensions.
Fixing clamps and brackets for square posts, corrosion protected for permanent outdoor use. For round posts, ask us with the tube diameter.
The matching fasteners and locking parts for the bolted joint — one system, one order.
Which bracket a panel needs depends on the post and on where in the run the panel sits. The guide to fixing welded wire mesh fence panels names the part for each case, with article designations and mesh pitches.
Post and ground
Brackets by post and ground
The post decides how the panel is held — and whether a catalog part covers it or a part to your drawing is the better answer. What the range is built for, in two lines.
| Post | What holds the panel | What to watch |
|---|---|---|
| Steel post, square | Clamp bracket or fixing plate bolted to the post, panel connector between panel and post | The standard case. The fence range is built around square posts, and the bracket grips the vertical wires of the panel |
| Steel post, round | Clamp sized to the tube diameter — not a catalog item | Round posts need clamps sized to the tube diameter, and those are not part of the standard range. Send us the outside diameter and the panel, and we will quote |
Concrete, foundations and masonry are a question of the ground rather than of the post. How a post is set in concrete or anchored with a base plate, and how the first and last panel of a run is tied into a wall, is covered in the guide to fixing welded wire mesh fence panels. The DIN and ISO fasteners for those joints are available ex stock Germany.
Match the material of panel, post and bracket to avoid galvanic corrosion — hot-dip galvanized for standard outdoor use, stainless steel for aggressive or coastal environments.
Where a post section, a dimension or a material falls outside the standard range, a bracket to your drawing is an ordinary order here rather than an exception — we build the forming tools for it ourselves. Send the post section and the panel with your inquiry.
Own production · own tool shop
Made in-house
Fence fixings are one of our core products. They are formed on our own presses, with forming tools designed and built in our own tool shop, under a quality management system certified to ISO 9001. Special dimensions and larger quantities are made to order.
The tool for a bracket stays with us. A second delivery runs against the same tool, so the hole pattern and the grip of the bracket do not drift between batches.
What is checked on a bracket is fixed in an inspection plan rather than left to the person at the press.
A fence run extended years after it was built gets the same bracket, not a near-enough substitute that has to be drilled to fit.
The screws, nuts and washers that complete the joint are standard parts to DIN and ISO. Those come from inspected European sourcing and are checked to the same criteria as the fixings we make ourselves. One contact for both, since 1943. Shipped worldwide from Germany.
Request a quotationRelated
Read on
Clamp brackets, panel connectors or edge clamps — which fixing suits which post, with article designations.
Formed parts made in our own tool shop, DIN and ISO standard parts from inspected European sourcing — one contact for both.
Screws, nuts and washers for fence assembly, from inspected European sourcing.
Get started
Start your project
Our engineering team will get back to you within 24 hours with a quotation for your project.
Mon–Fri, 9 am–4 pm CET/CEST · Technical advice