Mat clamps pull a double-wire mesh panel against a square post: the FC001 fixing plate (29 × 29 mm) as the flat standard, the FC002 fastening clamp that wraps around the wire, and the FC006 and FC007 edge fixings for the end of a run. Stainless steel 1.4301, in several hole patterns, from stock in Germany.
EDGE FIXING FC006, hole 5 mm, stainless steel 1.4301
Clamp for direct mounting on posts or masonry For assembly with M4 screws Stainless steel 1.4301
Content: 1 piece (€646.567000 / 1000 piece)
FC002 FIXING CLAMP, hole 9 mm, stainless steel 1.4301
Universal clamping plate for support brackets, stainless steel 1.4301 (A2) For assembly with hexagon socket head cap screws DIN 912 M8
Content: 1 piece (€1,303.775000 / 1000 piece)
FIXING PLATE FC001, 29x29 mm, hole 9 mm, stainless steel 1.4301
Universal clamping plate FC001 for support brackets, stainless steel 1.4301 Dimensions 29x29 mm For assembly with hexagon socket head cap screws DIN 912 M8
Content: 1 piece (€714.357000 / 1000 piece)
PANEL FIXING FC009, hole 5 mm, stainless steel 1.4301
Clamp for direct mounting on masonry For assembly with M4 screws Stainless steel 1.4301
Content: 1 piece (€665.781000 / 1000 piece)
Which version for which position
Along the run of the fence the flat FC001 plate is the standard. Where the holder has to grip the wire itself, the FC002 clamp is used. At the end of a run and at intermediate closures the FC006 and FC007 edge fixings take over. Panel joints are not covered here — that is the job of the mesh connectors.
Where to read on
The complete mounting sequence for a mesh fence is shown in the guide fixing welded wire mesh fence panels; post brackets and fittings under fence post brackets.
Frequently asked questions
What is a mesh clamp?
The part that pulls a double-wire mesh panel against the fence post – depending on the version a fixing plate, a fastening clamp or an edge fixing, in some cases via a support bracket. Mesh clamp, fence clamp and panel clamp all describe the same job.
Which versions are available?
The FC001 fixing plate (29 × 29 mm) as the flat standard plate, the FC002 fastening clamp that wraps around the wire, the FC006 and FC007 edge fixings for the end of the fence, and the FC008 and FC009 mesh fixings for intermediate positions.
Which hole pattern is the right one?
The hole follows the carriage bolt being used: 5, 7, 9 and 11 mm are available, plus a 9 × 11 mm slot for tolerance compensation, an 8.5 mm square hole against turning, and a 5 mm countersunk hole where no head may protrude.
Do mesh clamps fit round posts?
No, the holders are designed for square posts. ARNELL does not supply a fastening for round posts; it is worth asking before ordering.